Exfo FTB-2 User Manual download pdf (Page 401)

100

101

SCPI-Based Errors

FTB-2 and FTB-2 Pro 391

–312 “PUD memory lost” [Indicates that the protected user data saved by the

*PUD command has been lost.]

–313 “Calibration memory

lost”

[Indicates that nonvolatile calibration data used by

the *CAL? command has been lost.]

–314 “Save/Recall memory

lost”

[Indicates that the nonvolatile data saved by the

*SAV? command has been lost.]

–315 “Configuration

memory lost”

[Indicates that nonvolatile configuration data saved

by the device has been lost. The meaning of this

error is device-specific.]

–320 “Storage fault” [Indicates that the firmware detected a fault when

using data storage. This error is not an indication of

physical damage or failure of any mass storage

element.]

–321 “Out of memory” [An internal operation needed more memory than

was available.]

–330 “Self-test failed” -----

–340 “Calibration failed” -----

–350 “Queue overflow” [A specific code entered into the queue in lieu of

the code that caused the error. This code indicates

that there is no room in the queue and an error

occurred but was not recorded.]

–360 “Communication

error”

[This is the generic communication error for

devices that cannot detect the more specific errors

described for errors –361 through –363.]

–361 “Parity error in program

message”

[Parity bit not correct when data received for

example, on a serial port.]

–362 “Framing error in

program message”

[A stop bit was not detected when data was

received for example, on a serial port (for example,

a baud rate mismatch).]

Error

Number

Description Probable Cause

1 2 ... 396 397 398 399 400 401 402 403 404 405 406 ... 442 443

Comments to this Manuals

No comments

Exfo FTB-2 User Manual Page 401

Comments to this Manuals

Related products and manuals for Measuring instruments Exfo FTB-2